Ну что начнемс. Поставил я значит Mandrake 10.1, начал ставить по инструкции:
METHOD C: TAR PACKAGE (*.tar.gz)
If you have obtained the driver package in tar format:
1. extract the package with "tar -xzf hcfpcimodem-{version}.tar.gz"
("tar -xzf hcfusbmodem-{version}.tar.gz" for the USB version)
2. change to the package directory with "cd hcfpcimodem-{version}"
("cd hcfusbmodem-{version}" for the USB version)
3. run "make install" from the top of the package directory.
4. run "hcfpciconfig" ("hcfusbconfig" for the USB version) to complete
the installation and configure your modem.
Дошел вроде нормально до 4 этапа, далее ввожу hcfpciconfig и:
[root@localhost sasha]# cd hcfpcimodem-1.11full
[root@localhost hcfpcimodem-1.11full]# hcfpciconfig
Conexant HCF controllerless PCI modem driver, version 1.11full
If you need license keys, assistance or more information, please go to:
http://www.linuxant.com/When reporting a problem for the first time, please send
us the file generated by "hcfpciconfig --dumpdiag".
No pre-built modules for: Mandrake-10.1 linux-2.6.8.1-12mdk i686
Trying to automatically build the driver modules…
(this requires a C compiler and proper kernel sources to be installed)
Please install the 'kernel-source-2.6.8.1-12mdk' package. You can install
it with the 'urpmi kernel-source-2.6.8.1-12mdk' command.
Where is the linux source build directory that matches your running kernel?
[/usr/src/linux] urpmi kernel-source-2.6.8.1-12mdk
WARNING: missing file urpmi kernel-source-2.6.8.1-12mdk/include/linux/autoconf.h
The cause of this is usually a missing or unconfigured
kernel source tree (and sometimes an incorrect directory or symbolic link).
First, ensure that the proper kernel source and compiler packages
from your distribution vendor and/or the community are installed.
The Linux kernel can then be reconfigured by running "make menuconfig"
under the kernel source directory (usually /usr/src/linux).
Verify that the proper options for your system are selected.
Then compile and install your new kernel (for more information about
this procedure, see the README file under the kernel source directory),
reboot the system using the new kernel, and re-run "hcfpciconfig".
[root@localhost hcfpcimodem-1.11full]#
Что делать, я как понял у меня проблемы с ядром? помогите чайнику…
Добавлено: 24 янв 2007, 11:28:01